14-03-2013, 10:10 PM
Still no bits, or at least not all I need, so a bit more investigation.
I needed to find where all the external Connections went so that once fired up the (Voltage) feedback would be there.
These are the pink wires in the braid on a previous picture. I found most of them OK, but there were two which went into the braid at the PCB end but didn't seem to come out of the other. A count showed that there were 9 at the PCB end but only 7 at the other. There was nothing for it but to unclamp the braid and pull it back a bit. The answer was that a wire at the PCB end went a short way into the braid then looped round and came back out again. Ah, well, you live and learn.
I also moved some bits round on the Diagram to make it a bit more logical and more like the Manual Version, and added the external bits I identified - see attached.
With luck the bits should come tomorrow and I can get on.
Alan
I needed to find where all the external Connections went so that once fired up the (Voltage) feedback would be there.
These are the pink wires in the braid on a previous picture. I found most of them OK, but there were two which went into the braid at the PCB end but didn't seem to come out of the other. A count showed that there were 9 at the PCB end but only 7 at the other. There was nothing for it but to unclamp the braid and pull it back a bit. The answer was that a wire at the PCB end went a short way into the braid then looped round and came back out again. Ah, well, you live and learn.
I also moved some bits round on the Diagram to make it a bit more logical and more like the Manual Version, and added the external bits I identified - see attached.
With luck the bits should come tomorrow and I can get on.
Alan
