31-05-2013, 07:17 AM
(This post was last modified: 31-05-2013, 07:18 AM by Radio Fixer.)
It may not come back flat though, worth a try. If you make a new one is MDF stiffer than ply?
But what to brace it with? Not much room for any but small timber which will probably take up the bend or bend itself. In the past for sagging shelves I have used steel square tube from B&Q. Its very stiff of course and available in various sizes. You could drill through the baseboard into it and tap the holes. Then put screws, with washers, maybe where they don't show like under the deck itself.
Gary
But what to brace it with? Not much room for any but small timber which will probably take up the bend or bend itself. In the past for sagging shelves I have used steel square tube from B&Q. Its very stiff of course and available in various sizes. You could drill through the baseboard into it and tap the holes. Then put screws, with washers, maybe where they don't show like under the deck itself.
Gary
