I gave it ten minutes through a 15W lamp with all the valves out bar the rectifier.
I then cracked on with more re-capping doing all the ones around the output stage. The only problem I ran into was a needing a 25μF 25v electrolytic but I'd got a 32μF 450v one so that will do for now.
I thought it was time to test it again and after it had warmed up I touched the gram socket to make sure it wasn't live. This resulted in my getting a shock: not of the electrical sort but at the amount of noise which issued forth from the speaker. I connected my DAB radio to it and it seemed quite quiet and the sound quality was lousy. The latter though was down to the detached bellows and it sounded much better with those held in place.
I then saw if I could pick any stations up, without much hope at this stage but got things on all bands. I'll stick the bellows tonight so it can have a better test tomorrow. I'll also finish the re-cap and I haven't touched the cabinet yet.
Besides that it still needs a new mains lead, fuse and the wiring around the main switch needs attention. I've left that for now as I'm going to completely remove it so I can modify the end of the pot shaft so I can put the odd knob in the middle.
Oh yes: there's also the drive cord to do. I must have blotted that horror out of my mind. I'm worried because it looks like it'll be easy!
- Joe
I then cracked on with more re-capping doing all the ones around the output stage. The only problem I ran into was a needing a 25μF 25v electrolytic but I'd got a 32μF 450v one so that will do for now.
I thought it was time to test it again and after it had warmed up I touched the gram socket to make sure it wasn't live. This resulted in my getting a shock: not of the electrical sort but at the amount of noise which issued forth from the speaker. I connected my DAB radio to it and it seemed quite quiet and the sound quality was lousy. The latter though was down to the detached bellows and it sounded much better with those held in place.
I then saw if I could pick any stations up, without much hope at this stage but got things on all bands. I'll stick the bellows tonight so it can have a better test tomorrow. I'll also finish the re-cap and I haven't touched the cabinet yet.
Besides that it still needs a new mains lead, fuse and the wiring around the main switch needs attention. I've left that for now as I'm going to completely remove it so I can modify the end of the pot shaft so I can put the odd knob in the middle.
Oh yes: there's also the drive cord to do. I must have blotted that horror out of my mind. I'm worried because it looks like it'll be easy!
- Joe






