05-07-2011, 02:17 PM
Well, there's life in the beast.
As planned I had look at the speaker first as if that was u/s there wasn't a lot of point doing anything else.
The first thing I noticed was a bit of foam rubber jammed between the cone and frame which boded ill. However I've no done enough DAC90as to know about un-glued bellows and that's what's happened to this.
I couldn't make sense of the myriad coils or relate the circuit diagram to the real nuts and bolts. The best thing to do seemed to be to just test it.
I changed the two caps that Yorkie mentioned, though on my data THAT capacitor is C26. I hadn't got any 0.0047μF ones but have got 0.0022μF and 0.0033μF and space certainly isn't a problem.
When powered up everything glowed that should but nothing that shouldn't. It didn't actually play but at full volume there was a hum, though not a bad one, coming out of the speaker along with noise when the wave-switch was moved. I tried connecting my DAB radio directly (well direct save for a 0.1μF capacitor) to the grid of the output valve and it could be heard coming out of the speaker, albeit very quietly. I didn't leave it on for long as the lamp-limiter looked a bit bright.
As for the replacement volume pot/main switch, the contacts nearest the metal aren't connected. The fact it's a replacement probably explains the odd knob as the original wouldn't have fitted on the new shaft, at least not without modification thereto.
My next plan is to have a go at reforming the smoothers and then change some more of the small ones and see how it goes.
- Joe
As planned I had look at the speaker first as if that was u/s there wasn't a lot of point doing anything else.
The first thing I noticed was a bit of foam rubber jammed between the cone and frame which boded ill. However I've no done enough DAC90as to know about un-glued bellows and that's what's happened to this.
I couldn't make sense of the myriad coils or relate the circuit diagram to the real nuts and bolts. The best thing to do seemed to be to just test it.
I changed the two caps that Yorkie mentioned, though on my data THAT capacitor is C26. I hadn't got any 0.0047μF ones but have got 0.0022μF and 0.0033μF and space certainly isn't a problem.
When powered up everything glowed that should but nothing that shouldn't. It didn't actually play but at full volume there was a hum, though not a bad one, coming out of the speaker along with noise when the wave-switch was moved. I tried connecting my DAB radio directly (well direct save for a 0.1μF capacitor) to the grid of the output valve and it could be heard coming out of the speaker, albeit very quietly. I didn't leave it on for long as the lamp-limiter looked a bit bright.
As for the replacement volume pot/main switch, the contacts nearest the metal aren't connected. The fact it's a replacement probably explains the odd knob as the original wouldn't have fitted on the new shaft, at least not without modification thereto.
My next plan is to have a go at reforming the smoothers and then change some more of the small ones and see how it goes.
- Joe






