My plan had been to change THAT cap and then give it a go but after seeing the state that they are all in I'll do the lot. I'll certainly be working off the sheet as they are so discoloured that the values on the actual caps can't be read. I was rather pleased with myself when I identified THAT cap in the flesh, or rather in the wax, without looking at the sheet. The wiring looks OK as it's cloth covered rather than rubber.
It being a war-time set certainly make it interesting. It still has all the foreign names on the dial despite most of these been occupied at the time.
As to the speaker, I've had a quick poke around it with my continuity tester and not found anything alarming but will check that over properly before doing much else. It is a bit of a complication that all testing will need to be done through that one so till be putting some long temporary leads on it.
I'm certainly going to take my time on it and enjoy it.
- Joe
It being a war-time set certainly make it interesting. It still has all the foreign names on the dial despite most of these been occupied at the time.
As to the speaker, I've had a quick poke around it with my continuity tester and not found anything alarming but will check that over properly before doing much else. It is a bit of a complication that all testing will need to be done through that one so till be putting some long temporary leads on it.
I'm certainly going to take my time on it and enjoy it.
- Joe






