Yesterday, 07:15 PM
Well, pride before a fall, going back to AM I had no reception! Serves me right, I had changed 4 capacitors without checking after every one.
Spent an hour looking at what I had changed without finding any stupid mistakes. I had check every new component before fitting so it had to be a wrong connection, right?
Wrong. Turned out to be a ball of excess solder that had dropped into an unused hole in one of the IF transformer bases which unfortunately shorted the recessed unused pin to the chassis. I would have droppe in hot as it was stuck firmly to the plastic hence it didn't fall out.
Red face, now it worked fine with it removed.
I have changed all the Hunts moulded paper capacitors that have significant voltage DC on them on the presumption that they will be leaky and may in future go short circuit. I also changed the negative feedback and AGC capacitors. Now I have treble and a working tone control.
I have not changed any in the aerial end or on the filaments of the valves, I have found that these survive OK and cause no trouble.
So its all cleaning and cosmetic and reassembly from now on.
Sam.
Spent an hour looking at what I had changed without finding any stupid mistakes. I had check every new component before fitting so it had to be a wrong connection, right?
Wrong. Turned out to be a ball of excess solder that had dropped into an unused hole in one of the IF transformer bases which unfortunately shorted the recessed unused pin to the chassis. I would have droppe in hot as it was stuck firmly to the plastic hence it didn't fall out.
Red face, now it worked fine with it removed.
I have changed all the Hunts moulded paper capacitors that have significant voltage DC on them on the presumption that they will be leaky and may in future go short circuit. I also changed the negative feedback and AGC capacitors. Now I have treble and a working tone control.
I have not changed any in the aerial end or on the filaments of the valves, I have found that these survive OK and cause no trouble.
So its all cleaning and cosmetic and reassembly from now on.
Sam.
Boater Sam.







