06-10-2023, 06:18 PM
(This post was last modified: 06-10-2023, 06:28 PM by Mike Watterson.)
I do have a VHF and a UHF pair of Linears for the FT817ND, but the FT-991A is tempting as a second shack / base set. I think the Mirage BD 35 VHF/UHF dualband linear will give full output 45 W/35 W with about 3.5W in, about € 314 ex. VAT. So good for 817 or 818.
I don't have the BD 35, because I had a pair of PA's I'd bought S/H for the transverters* I used with the FT101ZD. The UHF one died, but I used the VHF one, an Alinco ELH-2300, which does 30W out for 3W in, so allows for some loss on feed cable if at the aerial end.
Later I replaced the dead UHF one with a Microset RU20 (from Classic International), which does 20W, maybe from 4W in (eating about 50W from the supply!). I must test. Both those will be for a pair of yagis on a rotator when I get round to putting them back up. Been down for a few years.
[A Microwave Modules 144-28 and 432-28. Perhaps MMT series. The VHF one may be still working but I think only the PA is intact on the UHF model. I have schematics, though there were many variations during production life.]
I don't have the BD 35, because I had a pair of PA's I'd bought S/H for the transverters* I used with the FT101ZD. The UHF one died, but I used the VHF one, an Alinco ELH-2300, which does 30W out for 3W in, so allows for some loss on feed cable if at the aerial end.
Later I replaced the dead UHF one with a Microset RU20 (from Classic International), which does 20W, maybe from 4W in (eating about 50W from the supply!). I must test. Both those will be for a pair of yagis on a rotator when I get round to putting them back up. Been down for a few years.
[A Microwave Modules 144-28 and 432-28. Perhaps MMT series. The VHF one may be still working but I think only the PA is intact on the UHF model. I have schematics, though there were many variations during production life.]







